Energy consumption optimisation
Energy consumption optimisation with SVE Optimize: automatic control of appliances, storage and charging according to energy prices and solar output. Less power bought from the grid, more of your own.
Your energy works when it is cheapest
Energy optimisation (SVE Optimize) is automatic control of appliances, storage and the charger so that they run when power is cheapest or comes from your panels. The system combines PV output data, hourly market prices (RCE), the weather forecast and your own habits, so you buy noticeably less expensive energy from the grid. It controls the battery, the car charger, the heat pump and the water heater in the background, with no daily clicking. We start with a consumption audit and configuration on your existing installation, without replacing it, and then tune the rules against real data from the first weeks.
Why it is worth it
Cheap power instead of expensive
The system starts energy-hungry equipment in the hours with the lowest price. Laundry, charging and water heating happen when the tariff is favourable.
Intelligent battery control
The battery charges from the panels or on cheap grid energy and discharges during peak hours. Self-consumption rises with no manual supervision.
Car charging from surplus
The charger starts when the panels produce a surplus or when power is cheapest. The car runs mostly on your own energy, not on expensive grid supply.
Response to hourly prices
SVE Optimize follows the market price of energy (RCE) and dynamic tariffs, matching how the installation runs to the actual rates for that day.
Works without your involvement
The rules are set once and then the system runs on its own. You can inspect and change everything in the app, but you do not have to watch the clock.
No replacement of the installation
We deploy optimisation on the equipment you already have. We add controllers and configuration, not a new PV system or battery from scratch.
After shifting load onto your own generation, instead of a typical 30%
Advantages and limits
- Reacts faster than a person
The system recalculates hourly prices and solar output every few minutes. You never miss the cheap hours or a surplus from the roof.
- Runs around the clock, including when you are away
Optimisation works while you are at work, on holiday or asleep. It does not need daily setting.
- Handles several variables at once
It weighs price, weather, battery state and your habits simultaneously, which is hard to track by hand.
- Scales to further devices
Add a heat pump or a second charger and the rules cover them without rebuilding everything.
- It needs controllable equipment
Some older inverters and appliances have no remote control. Occasionally a relay or controller has to be added.
- There is an upfront cost
Configuration and controllers are an initial expense. It returns through lower bills, but it is not free.
- The effect depends on your profile
The largest savings go to households with storage, a heat pump or an electric car. With PV alone the potential is smaller.
The process
Consumption and equipment audit
We analyse your invoices, load profile and existing devices: inverter, battery, heat pump, charger. We check what can be controlled and where the largest saving potential sits.
Design of the optimisation rules
We set the scenarios: which loads run, in which hours and at which prices. We simulate the effect on your own data before changing anything in the installation.
SVE Optimize configuration
We connect the inverter, battery and loads to the control system, feed in hourly price data (RCE) and the generation forecast, and switch the automatic rules on.
Tuning after the first weeks
Once running, we collect real data and correct the rules to raise self-consumption and cut grid purchases. Optimisation is a process, not a one-off setting.
What does optimisation cost?
| Audit and potential analysis consultation before implementation | PLN 0 |
| SVE Optimize configuration (PV + storage) rules and RCE price feed | from PLN 1,200 |
| Control of one load (heat pump, water heater, charger) controller and integration | from PLN 600 / device |
| Tuning and continuous installation care monitoring and rule correction | from PLN 49 / month |
Indicative gross prices in Polish złoty. Scope depends on how many devices we control and whether the equipment supports remote control. We give an exact quote after the free audit.
Example: a home with PV, storage and a heat pump
- SVE Optimize configuration
- from PLN 1,200
- Control of the heat pump and the charger
- from PLN 1,200
Related services
Complete energy solutions for your home and your business.
Want to know more? Let's talk about your project
Book a free consultation. We will go through your needs and give you an initial quote.